Manuals
Contents
Previous
Next
| | | |
| |||
| |||
| | | |
| ManualsContentsPreviousNext | | |
This section describes how to load paper in Tray 2.
Various sizes of paper can be loaded in Tray 2 by adjusting the positions of side fences and end fence.
If the paper tray is pushed vigorously when putting it back into place, the position of the side fences may slip out of place.
Check the paper edges are aligned with the right side.
The tray can hold up to 550 sheets. Do not stack paper over the limit mark.
Carefully pull out the paper tray until it stops.
Square the paper, and then load it print side down.
Carefully push the paper tray fully in.
If you load paper that cannot be automatically detected, specify its size using the display panel. For details, see "Changing to a Size That Is Not Automatically Detected".
 |
 | Copyright (C) 2010 |
