Skip headerPro C901
ManualsContentsPreviousNextHelp

Top Page > Troubleshooting > When the Machine Does Not Operate As Wanted > When Large Size Paper Is Not Properly Aligned > Finisher SR5000

Finisher SR5000

This section describes what to do if paper larger than B4 JIS or 81/2" × 14" is not properly aligned or falls from the finisher shift tray when using Finisher SR5000.

  1. Press the [Suspend/Resume] key.

    The key lights up.

    Finisher illustration

  2. Remove the prints.

  3. Pull out the finisher shift tray's extension.

    Finisher shift tray illustration

  4. Set the auxiliary paper tray.

    Attach the auxiliary paper tray by aligning the two protrusions on its underside with the holes on the tray extension.

    Finisher shift tray illustration

  5. Press the [Suspend/Resume] key.

    The key turns off, and then printing restarts.

TopPreviousNext
Copyright (C) 2010