Skip headerPro C901
ManualsContentsPreviousNextHelp

Top Page > Troubleshooting > When the Machine Does Not Operate As Wanted > When Z-folded Paper Is Not Properly Aligned > Finisher SR5000

Finisher SR5000

This section describes how to attach the Z-fold support tray for Finisher SR5000 to the finisher shift tray.

  1. Press the [Suspend/Resume] key.

    The key lights up.

    Finisher illustration

  2. Remove the prints.

  3. Set the Z-fold support tray for the finisher shift tray.

    Attach the Z-fold support tray by inserting the two protrusions on its underside into the holes on the finisher shift tray.

    Finisher shift tray illustration

  4. Press the [Suspend/Resume] key.

    The key turns off, and then printing restarts.

TopPreviousNext
Copyright (C) 2010