Directional Size Magnification (inch)

Specify the horizontal and vertical lengths of the original and copy image.

Copies can be reduced or enlarged at different reproduction ratios horizontally and vertically.

Illustration of Directional Size Magnification

Measure and specify the lengths of the original and copy by comparing “A” with “a” and “B” with “b”.

Press [Reduce / Enlarge].
Press [Dir. Size Mag. inch].
Enter the horizontal size of the original with the number keys, and then press [].
Enter the horizontal size of the copy with the number keys, and then press [].
Enter the vertical size of the original with the number keys, and then press [].
Enter the vertical size of the copy with the number keys, and then press [].
Press [OK] twice.

To change the value you entered, press the key you want to change, and then enter a new value.
You can specify a paper size of 1 9999 mm (0.1 99.9 inches) in units of 1 mm (0.1 inch).
The machine selects reproduction ratios of between 25.0 and 400.0%.
If the calculated ratio is over the maximum or under the minimum ratio, it is automatically adjusted within the available range. With certain ratios, parts of the image might not copy or margins will appear.
You cannot use Directional Size Magnification (inch) if Auto Paper Select is selected.