Coated Paper (Matted: Thick)

Printer setup

Press the [Menu] key, select [Paper Input], [Paper Type: (tray name)], and then select [Coated Paper(Matted:Thick)].

Printer driver setup

Click [Coated (Matted: Thick Paper)] in the "Paper Type:" list.

Supported paper feed tray

Any input tray can be used.

Make sure paper is not stacked higher than the upper limit mark ( ) inside the tray. When using the bypass tray, make sure paper is not stacked higher than the paper guides on the bypass tray.

Duplex printing

Not supported

Maintenance

Default: [CoatedPaper(Matted:Thick)1]

If prints made using the bypass tray show heavy smudging, use the following procedure to change the paper type setting from the control panel:

• Press the [Menu] key, select [Maintenance], [General Settings], and then select [Coated Paper(Matted:Thick)]. Select the bypass tray, and then select [CoatedPaper(Matted:Thick)1] or [CoatedPaper(Matted:Thick)2].

Note that this setting cannot be changed if you are printing from Tray 1 to 4. You can change this setting only when printing from the bypass tray.

When specifying paper thickness, remember that a higher number indicates greater thickness. Also, because the paper thickness will normally be detected automatically, change this setting only if a print problem occurs.

Additional cautions

Printing is slightly slower than when using plain paper.