Coated Paper (Matted)

Printer setup

Press the [Menu] key, select [Paper Input], [Paper Type: (tray name)], and then select [Coated Paper (Matted)].

Printer driver setup

Click [Coated (Matted)] in the "Paper Type:" list.

Supported paper feed tray

Any input tray can be used.

Make sure paper is not stacked higher than the upper limit mark ( ) inside the tray. When using the bypass tray, make sure paper is not stacked higher than the paper guides on the bypass tray.

Duplex printing

Supported

Maintenance

Default: [Coated Paper (Matted) 4]

If prints made using the paper tray show heavy smudging, use the following procedure to change the paper type setting from the control panel:

• Press the [Menu] key, select [Maintenance], [General Settings], and then select [Coated Paper (Matted) Stg.]. Select the paper tray, and then select one from [Coated Paper (Matted) 1], [Coated Paper (Matted) 2], [Coated Paper (Matted) 3], [Coated Paper (Matted) 4], or [Coated Paper (Matted) 5].

When specifying paper thickness, remember that a higher number indicates greater thickness. Also, because the paper thickness will normally be detected automatically, change this setting only if a print problem occurs.