Skip header
 

Correcting the Color Gradation

This section describes correcting the color gradation.

Color gradation during color printing can change slightly, depending on a number of factors. If you print the same file repeatedly or toner was recently replaced, changes may occur in color tones. In such cases, you can obtain optimal print results by correcting the color gradation.

Corrections to color gradation are performed in the following order:

  1. Print gradation correction sheet 1.

  2. Adjust the parts of highlight colors.

    Set the correction value.

    Print the gradation correction sheet, and then check the result of the correction.

  3. Print gradation correction sheet 2.

  4. Adjust the parts of middle colors.

    Set the correction value.

    Print the gradation correction sheet, and then check the result of the correction.

  5. Save the correction value.

Note

  • If suitable results cannot be obtained after a single operation, repeat the correction several times, as needed.

  • Corrections to color gradation will be applied to all user jobs.

  • Use the same type of paper when printing a run of gradation corrections. If a different type of paper is used, corrections may not be apparent.

  • This requires the use of the supplied Color Calibration Sample Sheet.