Coated Paper (Matted: Thick)
Printer setup |
Press the [Menu] key, select [Paper Input], [Paper Type: (tray name)], and then select [Coated Paper(Matted:Thick)]. |
Printer driver setup |
Click [Coated (Matted: Thick Paper)] in the "Paper Type:" list. |
Supported paper feed tray |
Any input tray can be used. Make sure paper is not stacked higher than the upper limit mark ( |
Duplex printing |
Not supported |
Maintenance |
Default: [CoatedPaper(Matted:Thick)1] If prints made using the bypass tray show heavy smudging, use the following procedure to change the paper type setting from the control panel:
Note that this setting cannot be changed if you are printing from Tray 1 to 4. You can change this setting only when printing from the bypass tray. When specifying paper thickness, remember that a higher number indicates greater thickness. Also, because the paper thickness will normally be detected automatically, change this setting only if a print problem occurs. |
Additional cautions |
Printing is slightly slower than when using plain paper. |
) inside the tray. When using the bypass tray, make sure paper is not stacked higher than the paper guides on the bypass tray.
