Label paper

Printer setup

Press the [Menu] key, select [Paper Input], [Paper Type: (tray name)], and then select [Label Paper].

Printer driver setup

Click [Labels] in the "Paper Type:" list.

Supported paper feed tray

Any input tray can be used.

Make sure paper is not stacked higher than the upper limit mark ( ) inside the tray. When using the bypass tray, make sure paper is not stacked higher than the paper guides on the bypass tray.

Duplex printing

Not supported

Maintenance

Default: [Label Paper 6]

If prints made using the paper tray show heavy smudging, use the following procedure to change the paper type setting from the control panel:

• Press the [Menu] key, select [Maintenance], [General Settings], and then select [Label Paper Setting]. Select the paper tray, and then select one from [Label Paper 1], [Label Paper 2], [Label Paper 3], [Label Paper 4], [Label Paper 5], or [Label Paper 6].

When specifying paper thickness, remember that a higher number indicates greater thickness. Also, because the paper thickness will normally be detected automatically, change this setting only if a print problem occurs.