Skip header
 

Letterhead

Printer setup

Press the [Menu] key, select [Paper Input], [Paper Type: (tray name)], and then select [Letterhead].

Printer driver setup

Click [Letterhead] in the "Paper Type:" list.

Supported paper feed tray

Any input tray can be used.

Make sure paper is not stacked higher than the upper limit mark (Down arrow key ) inside the tray. When using the bypass tray, make sure paper is not stacked higher than the paper guides on the bypass tray.

Duplex printing

Supported

Maintenance

Default: [Letterhead 2]

If prints made using the paper tray show heavy smudging, use the following procedure to change the paper type setting from the control panel:

  • Press the [Menu] key, select [Maintenance], [General Settings], and then select [Letterhead Setting]. Select the paper tray, and then select one from [Letterhead 1], [Letterhead 2],[ Letterhead 3], [Letterhead 4] or [Letterhead 5].

When specifying paper thickness, remember that a higher number indicates greater thickness. Also, because the paper thickness will normally be detected automatically, change this setting only if a print problem occurs.