Setting Up a Client Computer

Follow the procedure below to configure a computer as a client computer and connect it to the shared printer. Make this setting when installing the printer driver from the CD-ROM provided.

Only administrators can make this setting. Log on as a member of the Administrators group.

Configure a computer connected to the network where the print server is connected.

Start Windows, and then insert the CD-ROM into the CD-ROM drive.
Quit all other applications currently running.
When starting Windows, a wizard for adding new hardware may open. If this happens, click [Cancel]. Check again that the power is off.
Select a language for the interface, and then click [OK].
Click [Printer Driver].
If your model is the GX e3350N, click [PCL/RPCS Raster Printer Drivers].
Read the entire license agreement carefully. If you accept its terms, click [I accept the agreement.], and then click [Next >].
Click [Connected via LAN].
Click [Next >].
Click the plus mark next to a printer name.
Click [Port:< LPT1: >] under [Printer name:].
Click [Add].
Click [Network Printer].
Click [OK].
Select a shared printer.
Click [OK].
Check that [<\\servername\sharedprintername>] appears after [Port:].
Click [Continue].
Installation starts.
Select whether or not to open the Status monitor automatically.
Click [Next >].
Check the installation result, and then click [Finish].

Auto Run might not work automatically with certain OS settings. If this is the case, double-click the CD-ROM drive icon under [My Computer] or [Explorer], and then double-click [SETUP.EXE].
If the message prompting you to restart the computer appears, restart the computer.