Skip headerimage
ContentsPreviousNextHelp

Replacing the Print Cartridge

WARNING

  • Do not incinerate used toner or toner containers. Toner dust might ignite when exposed to an open flame. Dispose of used toner containers in accordance with local regulations.

  • Do not store toner, used toner, or toner containers in a place with an open flame. The toner might ignite and cause burns of a fire.

  • Keep the polythene materials (bags, gloves, etc.) supplied with this machine away from babies and small children at all times. Suffocation can result if polythene materials are brought into contact with the mouth or nose.

CAUTION

  • Keep toner (used or unused) and toner containers out of reach of children.

  • If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.

  • Avoid getting toner on your clothes or skin when removing a paper jam or replacing toner. If your skin comes into contact with toner, wash the affected area thoroughly with soap and water.

  • If toner gets on your clothing, wash with cold water. Hot water will set the toner into the fabric and may make removing the stain impossible.

  • If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.

  • If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.

  • The inside of this machine becomes very hot. Do not touch parts labelled "" (indicating a hot surface).

Important

Messages on the screen

  • Replace the print cartridge when "Life End Print Cartridge" appears on the screen.

  • Prepare a new print cartridge when "Near End Print Cartridge" appears on the screen.

Important

  1. If paper is loaded in the bypass tray, remove the paper and close the bypass tray.

  2. Push the side button to open the front cover, and then carefully lower it.

    image

  3. Carefully pull out the print cartridge horizontally, holding its center.

    image

    • Do not shake the removed print cartridge. Doing so can cause remaining toner to leak.

    • Place the old print cartridge on paper or similar material to avoid dirtying your workspace.

  4. Take the new print cartridge out of the box, and then take it out of the plastic bag.

    image

  5. Place the print cartridge on a flat surface, and then remove the protection sheet.

    image

  6. Hold the print cartridge and shake it from side to side five or six times.

    image

    Even distribution of toner within the bottle improves print quality.

  7. Slide the print cartridge in horizontally. When the cartridge can go no further, raise it slightly and push it fully in. Then push down on the cartridge until it clicks into place.

    image

  8. Carefully push up the front cover until it closes. Be careful not to trap your fingers.

    After closing the front cover, wait until the initial screen is displayed.

    image

  9. Put the protective sheet you removed in step 5. on the old print cartridge. Then, put the old print cartridge into the bag, and then put it into the box.

    image

    Note

    • Make sure to cover the old print cartridge with the protective sheet for recycling and environmental purposes.

    • Comply with the print cartridge Recycling Program, whereby used print cartridges are collected for processing. For details, ask your sales or service representative.