Loading Paper in the Bypass Tray

Set the size and direction of the loaded paper using Smart Organizing Monitor or the printer driver. Make sure the settings do not conflict. Otherwise, the paper may jam or the print quality may be affected.
Load paper with the print side up, and in the short-edge feed direction.
If paper is curled, straighten it before loading, by bending it the paper in the opposite direction to the curl, for example.
Do not load paper while the printer is printing.
You cannot load paper when the printer is in Energy Saver mode. To disable Energy Saver mode, click the [Stop/Start] key on the control panel.

Open the bypass tray.
If you load A4 (297 mm) or larger size paper, pull out the bypass tray extension.
Slide the side guides outward, then load paper with the print side up, and push in until it stops against the printer.
Adjust the side guides to the paper width.
- After loading paper in the tray, specify the paper type and size using Smart Organizing Monitor or the printer driver.
- For details about supported types of paper, see Supported Paper for Each Tray.
- For details about specifying the paper type and size, see Software Guide.