Loading Paper into the Paper Trays
This section describes how to load paper into the paper trays.
Various sizes of paper can be loaded in the paper trays by adjusting the positions of side fences and end fence.
Check the paper edges are aligned with the right side.
Each tray can hold up to 500 sheets of paper. Do not stack paper over the limit mark.
When loading small quantities of paper, be careful not to squeeze the side fences in too tightly, as the paper will not feed properly.
If you add paper to a paper tray with paper left inside, a misfeed might occur.
Make sure the paper tray is not in use.
Pull the paper tray out slowly until it stops.
While pinching the release lever, slide the end fence outward.
Square the paper and place it print side up.
Do not stack paper over the limit mark.
Position the end fence flush against the paper.
Push the paper tray in until it stops.
