Skip header
 

Top Page > About This Machine > Adding Paper > Loading Paper > Loading Paper into the Large Capacity Tray

Loading Paper into the Large Capacity Tray

This section describes how to load paper into the LCT.

Important

  • The LCT uses 81/2 × 11Portrait paper exclusively. If you want to load A4Portrait or B5 JISPortrait, contact your service representative.

  • The optional extension unit is required to load B4 JISLandscape, A4Landscape, 81/2 × 14Landscape, or 81/2 × 11Landscape into the LCT.

  • Align the paper neatly and press its edge to the right and left plate. Poorly loaded paper causes misfeeds.

  • Check the paper edges are aligned at the left side.

1Open the top cover of the LCT.

LCT illustration

2Press the [Down] key.

The key blinks while the bottom plate is moving down.

LCT illustration

3Load paper into the tray along the edge on the left.

Load the paper print side up. Do not stack paper over the limit mark.

LCT illustration

4Close the top cover of the LCT.

Note

  • The tray can hold up to 4,000 sheets.