Copying onto Tab Stock

You can copy onto tab stock.

Illustration of copying onto tab stock

Before using this function, set the tray for tab stock and set the position of the index tab under Paper Type in User Tools. For details about Paper Type, see “System Settings”, Network and System Settings Reference.
1. Original width
2. Index width
Specify the size of tab stock under Tray Paper Size in User Tools. The sizes that can be used are A4, 8¹/₂ × 11, and 8¹/₂ × 14. For details about Paper Size, see “System Settings”, Network and System Settings Reference.
Tab stock can be loaded in trays 2 and 3 or the wide LCT. When loading tab stock in tray 2 or 3, load tab stock with the side to be copied facing down. When loading tab stock in the wide LCT, load tab stock with the side to be copied facing up.
When loading tab stock, always use the tab sheet holder.
Load tab stock so that it will be fed from the side without the tab first.
When loading tab stock in tray 2 or 3, adjust the back fence position so that the tab sheet holder will fit the tab stock.
The Duplex function cannot be performed on tab stock. If [1 Sided 2 Sided] is selected, cancel the setting.

Tab stock is fed starting from the top tab.

Select the paper tray where the tab stock is loaded.

Operation panel screen illustration

Place the originals, and then press the [Start] key.

Check the position of the index tab to avoid cropping the image.
Align the image you want to copy by checking the position of the index tab. If the image extends beyond the index tab, the backs of sheets may get soiled with toner.
To copy onto tab stock from the bypass tray, see “Copying onto Tab Stock from the Bypass Tray”.
To copy onto tab stock from the wide LCT, see “Copying onto Tab Stock from the Wide Large Capacity Tray”.
When a paper jam has occurred, check the order of originals and tab stock, and then restart copying.