General Settings

Replacement Alert

Use this function to specify the timing to notify user when supplies need to be replaced. Settings can be made separately for photo conductor unit, intermediate transfer unit, or fusing unit.

Fusing Unit
Default: [Normal]
- Notify Sooner
- Normal
- Notify Later

Supply End Option

You can specify whether or not to continue printing after the photoconductor exceeds its service life.

Default: [Continue Printing]

Continue Printing
Stop Printing

Display Supply Info

You can select whether or not the amount of toner is displayed on the initial screen.

Default: [On]

Envelope Lever Alert

You can select whether or not the position of the envelope lever is displayed on the initial screen.

Default: [Display]

Display
Do not Display

Menu Protect

You can select whether or not to protect the menu settings. If you enable this setting, you must specify a protection level.

Default: [Level 2]

Level 1
Level 2
Off

If you would like to lower the protection level, disable this setting or select [Level 1].
You may not be able to change this setting depending on the setting of the printer.

List/Test Print Lock

You can select whether or not to prohibit List/Test printing.

Default: [Off]

You may not be able to change this setting depending on the setting of the printer.

Unit of measure

You can specify the unit for measurement.

Default:

: [mm]

: [inch]

mm
inch

Panel Key Sound

You can select whether or not to enable the panel key sound.

Default: [On]

Warm-up Beeper

You can select whether or not to sound the beeper when the printer has completed a warm-up process.

Default: [Off]

Display Contrast

You can specify the density of the display.

Key Repeat

You can specify whether or not to scroll the display panel when the [ ] or [ ] key is held down. When you enable this setting, specify the scroll speed. (If repeat time is set to "Long", scroll speed becomes slow.)

Default: [Normal]

Do not Repeat
Normal
Repeat Time: Medium
Repeat Time: Long