General Settings
Replacement Alert
Use this function to specify the timing to notify user when supplies need to be replaced. Settings can be made separately for photo conductor unit, intermediate transfer unit, or fusing unit.
Fusing Unit
Default: [Normal]
Notify Sooner
Normal
Notify Later
Supply End Option
You can specify whether or not to continue printing after the photoconductor exceeds its service life.
Default: [Continue Printing]
Continue Printing
Stop Printing
Display Supply Info
You can select whether or not the amount of toner is displayed on the initial screen.
Default: [On]
On
Off
Envelope Lever Alert
You can select whether or not the position of the envelope lever is displayed on the initial screen.
Default: [Display]
Display
Do not Display
Menu Protect
You can select whether or not to protect the menu settings. If you enable this setting, you must specify a protection level.
Default: [Level 2]
Level 1
Level 2
Off
If you would like to lower the protection level, disable this setting or select [Level 1].
You may not be able to change this setting depending on the setting of the printer.
List/Test Print Lock
You can select whether or not to prohibit List/Test printing.
Default: [Off]
On
Off
You may not be able to change this setting depending on the setting of the printer.
Unit of measure
You can specify the unit for measurement.
Default:
: [mm]
: [inch]
mm
inch
Panel Key Sound
You can select whether or not to enable the panel key sound.
Default: [On]
On
Off
Warm-up Beeper
You can select whether or not to sound the beeper when the printer has completed a warm-up process.
Default: [Off]
On
Off
Display Contrast
You can specify the density of the display.
Key Repeat
You can specify whether or not to scroll the display panel when the [
] or [
] key is held down. When you enable this setting, specify the scroll speed. (If repeat time is set to "Long", scroll speed becomes slow.)
Default: [Normal]
Do not Repeat
Normal
Repeat Time: Medium
Repeat Time: Long
