Manuals
Contents
Previous
Next
| | | |
| |||
| |||
| | | |
| ManualsContentsPreviousNext | | |
This section describes how to remove punch waste from the finisher.
Open the front cover of the finisher.
Pull out the punch waste box carefully, and then remove punch waste.
Reinstall the punch waste box.
Close the finisher front cover.
While "
Hole Punch Receptacle is full." is displayed, you cannot use the punch function.
"Hole Punch Receptacle is full." is displayed until the punch waste box is reinstalled.
If the message is still displayed, reinstall the punch waste box.
 |
 | Copyright (C) 2008, 2009 |
