Changing the Paper Size in the Wide Large Capacity Tray

This section explains how to change the paper size in the Wide Large Capacity Tray.

Check that the paper edges are aligned with the left side.
Do not stack paper over the limit mark.
When loading tab stock, set the tab sheet fence in the Wide Large Capacity Tray.

Carefully pull out the paper tray until it stops.
Remove the screws holding the side fences in position.
While pinching the positioning tabs, slide the side fences into position according to the size of the paper you want to load.
Fasten the side fences with the screws.
Release the lock on the end fence.
Square the paper and set it print side up.
Tightly fit the back fence to the loaded paper and then re-lock the end fence again.
Carefully slide the paper tray fully in.
Check the size on the display.