Skip headerPro 907/Pro 1107/Pro 1357
ManualsContentsPreviousNextHelp

If the Paper Fed to the Output Tray Is Still Not Aligned

If Z-folded sheets are not output in proper alignment even when the Z-fold support tray for the Folding Unit (Large) is attached, attach the Z-fold support tray for the Folding Unit (Small) as well.

  1. Open the front cover of the Folding Unit and remove both Z-fold support trays (located at the bottom of the Folding Unit).

    Folding Unit illustration

  2. Insert the projecting part of the small Z-fold support tray into the rectangular hole of the large Z-fold support tray.

    Folding Unit illustration

    A) Z-fold support tray for the Folding Unit (Small)

    B) Projecting part

    C) Rectangular hole

    D) Z-fold support tray for the Folding Unit (Large)

  3. Position both Z-fold support trays flush against the end fence in the slope of the Folding Unit Tray.

    Folding Unit illustration

Note