Skip header
 

Top Page > Troubleshooting > Appendix > Pausing Copying When Using the Finisher SR5000 or the Booklet Finisher SR5020

Pausing Copying When Using the Finisher SR5000 or the Booklet Finisher SR5020

Use the following procedure to temporarily interrupt a long copy run when using the Finisher SR5000 or the Booklet Finisher SR5020.

1Press the [Suspend/Resume] key.

The key lights and printing stops.

Finisher suspend/resume key illustration

2Remove the stack of paper from the Finisher Shift Tray.

Finisher illustration

3Press the [Suspend/Resume] key.

The key turns off, and then copying restarts.

Note

  • You can suspend copy only when the output tray is specified as the Finisher Shift Tray.

  • Depending on the print image, the prints might not be stacked properly. In such a case, pause printing, remove the prints, and then resume printing.