Skip headerGelSprinter GX e2600/GX e3300N/GX e3350N
ContentsPreviousNextHelp

Quick Install for USB

Follow the procedure below to install the printer driver and User Guide.

Important

Notes on the Installation (USB Connection)

If the message "Digital Signature Not Found" or the [Software Installation], [Hardware Installation] or [Windows can't verify the publisher of this driver software] dialog box appears:

  1. Click [Yes], [Continue Anyway] or [Install this driver software anyway] to continue the installation.

If the [Found New Hardware Wizard] dialog box appears:

  1. Click [Install from a list or specific location (Advanced)], and then click [Next >].

  2. Click [Include this location in the search], and then click [Browse].

  3. Browse to "DRIVERS" on the CD-ROM, and then click [OK]. Select the folder appropriate for your operating system.

    Be sure to clear the [Search remove media (floppy, CD-ROM...)] check box.

    For details about the files stored on the CD-ROM labeled, see Software on the CD-ROM.

  1. Start Windows, and insert the provided CD-ROM into the CD-ROM drive.

    Quit all applications currently running.

    When you start Windows, the "Add New Hardware Wizard" may appear. If this happens, click [Cancel]. Check again that the power is off.

  2. Select a language for the interface, and then click [OK].

  3. Click [Quick Install for USB].

  4. Read the entire license agreement carefully. If you accept its terms, click [I accept the agreement.], and then click [Next >].

  5. Check that the power of the printer is off, and then click [Next >].

  6. Check again that the power of the printer is off, and then click [Next >].

    Check that the dialog box below appears.

    If the [Software Installation] or [Windows can't verify the publisher of this driver software] dialog box appears, see "Notes on the Installation".

  7. Make sure that the computer and printer are properly connected, and then press the [Power] key.

    Installation starts.

    If the connection to the computer was not confirmed, make the port settings again after installation is complete.

    If the message "Digital Signature Not Found" or the [Found New Hardware Wizard] or [Hardware Installation] dialog box appears, see "Notes on the Installation".

  8. Select whether or not to open the printer status monitor automatically, and then click [Next >].

  9. Check the installation result, and then click [Next >].

    Install User Guide.

  10. Click [Finish].

    The printer driver and User Guide are now installed.

    If the message "Digital Signature Not Found" or the [Found New Hardware Wizard] or [Hardware Installation] dialog box appears, see "Notes on the Installation".

Note