Machine Rear

GX e3300N/GX e3350N

1. USB slot

   Connect the USB cable from the computer here.

2. Ethernet port (GX e3300N/GX e3350N only)

   Use a network interface cable to connect the printer to a network.

3. Duplex Unit (GX e3300N/GX e3350N only)

   Turns the paper over when performing duplex printing.

4. Vent

   Air is vented here to prevent the inside of the printer from getting too warm. Do not lean anything against the vent or block it in any way. If the inside of the printer gets too warm, a breakdown could occur.

5. Power inlet

   Plug the power cord.

   Plug one end of the power cord into the printer's power inlet and the other end into a wall outlet.

   Connect the grounding wire attached to the power plug directly to a grounding terminal.

6. Guide board

   To remove paper that has jammed inside the printer, open the guide board by removing the rear cover.

7. Rear cover (GX e2600 only)

   Open this to remove paper that has become jammed inside the printer.