Replacing the Waste Toner Bottle

Do not incinerate spilled toner or used toner. Toner dust might ignite when exposed to an open flame.
Wait for 30 minutes or more after disconnecting the power plug before removing the transfer unit.
Do not incinerate used toner or toner containers. Toner dust might ignite when exposed to an open flame. Dispose of used toner containers in accordance with local regulations.

The inside of this printer becomes very hot. Do not touch parts labelled "" (indicating a hot surface).
Keep toner (used or unused) and toner containers out of reach of children.

When to replace the waste toner bottle

If the Alert indicator on the control panel lights up and the following message appears on the display, replace the waste toner bottle:

"Replace Waste Toner"

Waste toner bottles cannot be reused.
Purchasing and storing extra waste toner bottles is recommended.
When removing the waste toner bottle, make sure not to tilt it.
Keep the waste toner bottle horizontal as you take it out.
Make sure that the transfer unit is installed. If the transfer unit is not installed, install it before turning the power on.
Cooperate with the waste toner bottle Recycling Program, whereby used waste toner bottles are collected for recycling.

Pull Front Cover Open Lever, and then open the front cover with both hands carefully.
Slide both levers on the front cover outward.
Hold both ends of the transfer unit, and then lift it up.
Hold the center of the waste toner bottle, and then carefully pull it out horizontally.
Pull the waste toner bottle halfway out, grab the bottle, and then pull it straight out.
To prevent the waste toner bottle touching the intermediate transfer unit, do not lift the bottle while pulling it out.
Close the bottle cap.
Hold the center of the new waste toner bottle, and then carefully insert it halfway into the printer body.
Leave the cap open.
To prevent the waste toner bottle touching the intermediate transfer unit, do not lift the bottle while inserting it.
Push in the waste toner bottle until it clicks into place.
Push the green part all the way in.
Place the transfer unit down on the front cover.
Slide the transfer unit along the guide rails into the printer. When it stops, push on the green PUSH mark until it clicks into place.
Close the front cover with both hands carefully.
- Before removing the waste toner bottle from the printer, spread paper or some other material around the area to keep toner from dirtying your workspace.