Exterior: Side View

Optional Interface Board Slot

Optional interface boards can be inserted.

Insert an optional IEEE 802.11 wireless interface unit, Bluetooth interface unit or IEEE 1284 interface board.

Expansion Card Slots

Remove the cover to install SD cards.

Upper slot: Data overwrite security unit, camera direct print card, NetWare card

Lower slot: HDD encryption unit, VM card

USB Port B

Use a USB cable to connect the printer to a host computer.

Ethernet Port

Use a network interface cable to connect the printer to the network.

USB Port A

Connect external devices to the printer, such as a digital camera.

Controller Board

Slide this out to install options such as the SDRAM module, hard disk, or Gigabit Ethernet board.

Ventilator

Releases heat from internal components to prevent overheating. Do not place objects against or near these holes. Doing so results in printer malfunction.

Replace the dustproof filter when the "Replace IntTrans Unit soon." message appears on the display. Replace it with the transfer unit together.

Power Connector

Connect the power cable to the printer. Insert the other end into an electrical outlet.

Drying Heater Switch

If the paper in the paper tray is moist due to high humidity, the print quality may decrease. The drying heater prevents moisture. If humidity is high, turn the switch on.

Handle

Hold this handle when you pull out the controller board.

Optional Gigabit Ethernet Board Slot

By removing this cover and installing the optional Gigabit Ethernet board, you can connect an Ethernet cable to the printer.