Skip headerimage
ContentsPreviousNextHelp

Installing the Paper Feed Unit TK1010 (Tray 2)

CAUTION

  • The machine weighs approximately 30.0 kg (66.2 lb.). When moving the machine, use the inset grips on both sides, and lift slowly in pairs. The machine will break or cause injury if dropped.

  • Lifting the paper feed unit carelessly or dropping may cause injury.

  • It is dangerous to handle the plug with wet hands. Doing this may result in receiving an electric shock.

  • Before moving the machine, unplug the power cord from the wall outlet. If the cord is unplugged abruptly, it could become damaged. Damaged plugs or cords can cause an electrical or fire hazard.

Important

  1. Check that the package contains Paper Feed Unit TK1010.

    image

  2. Turn off the power, and then unplug the machine's power cord from the wall outlet.

  3. Remove the adhesive tape from the optional paper feed unit.

    image

  4. Lift using the inset grips on both sides of the machine.

    image

  5. There are three upright pins on the optional paper feed unit. Align them with the holes on the underside of the machine, and then carefully lower the machine onto them.

    image

  6. After installing the option, print the configuration page to confirm the installation.

    If it is installed properly, "Tray 2" will appear under "Tray Info" on the configuration page.

    Note

    • After installing the optional paper feed unit, select tray 2 in the printer driver. For details, see the printer driver Help.

    • If the optional paper feed unit is not installed properly, reinstall it following this procedure. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative.

    Reference