



	Contents Previous Next

Top Page > Getting Started > Connecting the Machine > Connecting to a Telephone Line

Connecting to a Telephone Line

You can connect the machine to the public switched telephone network (PSTN) directly or through a private branch exchange (PBX).

Also, you can connect an external telephone to use the same telephone line for voice calls.

: To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.

: Pour réduire le risque d'incendie, utiliser uniquement des conducteurs de télécommunications 26 AWG ou de section supérieure.

: By law in the United States, you must program your phone number identification (your fax number) into your machine before you can connect to the public phone system.
Make sure the connector is the correct type before you start.

Connect a telephone line cord to LINE.
If using an external telephone, connect the telephone to TEL.
- After connecting the machine to the telephone line, configure the telephone line type.
- If your telephone has functions that are not compatible with this machine, those functions will not be usable.
- Confirm that you have registered user fax number and user name during Initial Setup. You can check the registered information in [User Settings] under [Admin Settings].
- For details about registering fax sender information, see Administrator Settings.
- For details about configuring the telephone line type, see Configuring Telephone Network Settings.
- For details about [User Settings], see Administrator Settings.