Skip header
 

Convert Colors

Copies by changing a certain color in the original to another color.

Important

  • Up to four colors can be converted at the same time.

  • To use this function, [Full Color] must be selected.

  • If any other color mode is selected, you cannot select [Convert Color].

1Press [Full Color].

Operation panel screen illustration

2Press [Edit / Color].

Operation panel screen illustration

3Press [Color], and then press [Convert Color].

4Select any one item from [Conversion 1] to [Conversion 4].

Operation panel screen illustration

5Selects the color to be converted.

6Selects the new color.

You can adjust the density of the color in four steps.

To select user color, press [User Color], and then select the color.

To change more than two colors, repeat steps 4 to 6.

7After selecting all colors to be converted, press [OK] three times.

8Place the originals, and then press the [Start] key.

Note

  • The width of the color to be converted can be adjusted in five levels. When the width of the color is set to [Wider] under Color Sensitivity in User Tools and red has been specified, colors close to orange and purple will be converted. You can change the setting. For details about Color Sensitivity, see “Adjust Color Image”.

  • To change the converted color, press from [Conversion 1] to [Conversion 4], and then make the selection again.

  • The full color counter will advance by “1”.

  • For examples of what you can do with the color functions, see “Available Color Functions”.