Skip headerimage
ManualsContentsPreviousNextHelp

Changing the Paper Size in the Paper Trays

This section describes how to change the paper size in the paper trays.

Important

  1. Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.

    Paper tray illustration

  2. Press the metal plate down until it clicks.

    Paper tray illustration

  3. Remove paper if loaded.

  4. Release the lock on the side fences.

    Paper tray illustration

  5. While pressing down the release lever, slide the side fences until they are aligned with the paper size you want to load.

    Make sure there are no gaps between the paper and side fences.

    Paper tray illustration

  6. Slide the end fence until it is aligned with the size of paper to you want to load.

    Make sure there are no gaps between the paper and end fence.

    Paper tray illustration

  7. Square the paper and load it print side up.

    Do not stack paper over the limit mark.

    Paper tray illustration

  8. Re-lock the side fences again.

    Paper tray illustration

  9. Carefully slide the paper tray fully in.

  10. Check the size on the display.