Skip header
 

Top Page > Hardware Guide > Guide to the Printer > Exterior: Rear View

Exterior: Rear View

This section explains names and functions of the parts on the rear side of the printer.

Rear side of the printer illustration

  1. Controller Board

    Slide this out to install options such as the memory unit or printer hard disk. Plug cables such as the USB cable and Ethernet cable into their connectors.

  2. Ethernet Port

    Use a network interface cable to connect the printer to the network.

  3. USB Port

    Use a USB cable to connect the printer to a computer.

  4. Optional Interface Board Slot

    Insert an optional Wireless LAN interface unit, Bluetooth interface unit, Gigabit Ethernet board, or 1284 interface board in this slot.

  5. SD Card Slots

    Install SD cards in these slots. There are two slots.

    When you use the SD card, use the right slot.

  6. USB Host Port

    Use a USB cable to connect the printer to the digital camera.

  7. Front Cover (A) Open Levers

  8. Left Cover

    Open this cover when replacing the photo conductor unit (PCU), intermediate transfer unit or waste toner bottle.

  9. Power Cable

    Illustration of 220 to 240 V model The power cable is separated. Connect the power cable to the printer.

    Illustration of 120 V model The power cable is fixed to the back side.