ManualsContentsPreviousNext |
Configure the printer to use wireless LAN. The following table shows the control panel settings and their default values. These items appear in the [Host Interface] menu.
Setting Name |
Default Value |
---|---|
Comm. Mode |
802.11 Ad hoc |
Channel |
11 |
Trans. Speed |
Auto |
SSID |
blank |
Security Method |
None |
To use wireless LAN, set as the followings using the control panel: press the [Menu] key, and then select [Host Interface], [Network Setup], [LAN Type], and then [IEEE 802.11b]. Also, set the IPv4 Address, Subnet Mask, Gateway Address, DHCP, Frame Type (NW), and Active Protocol under the [Network Setup] menu. For details about setting items, see Ethernet Configuration.
The wireless LAN interface unit cannot be used simultaneously with a standard ethernet interface.
The optional wireless LAN interface unit supports 802.11 Ad hoc and Infrastructure modes. Select [802.11 Ad hoc] or [Infrastructure] for [Comm.Mode].
Press the [Menu] key.
The [Menu] screen appears.
Press the [] or [] key to display [Host Interface], and then press the [ Enter] key.
Press the [] or [] key to display [IEEE 802.11b], and then press the [ Enter] key.
Press the [] or [] key to display [Comm. Mode], and then press the [ Enter] key.
Press the [] or [] key to select the transmission mode of wireless LAN, and then press the [ Enter] key.
The factory default is [802.11 Ad hoc].
The transmission mode of wireless LAN can also be set using a Web browser. For details, see Web browser, and "Configuring the Network Interface Board", Software Guide.
If [802.11 Ad hoc] is selected for [Comm. Mode], set the channel to use for transmission.
Confirm the network administrator for the channel to use.
In the [IEEE 802.11b] menu, press the [] or [] key to display [Channel], and then press the [ Enter] key.
Press the [] or [] key to set the channel, and then press the [ Enter] key.
Set [Trans. Speed] in the same way.
The factory default is [Auto]. If you need to change the transmitting speed depending on environment you are using, select the appropriate transmitting speed.
Print a configuration page to confirm the settings made.
"Printing the Test Page", Quick Installation Guide.