Skip headerimage
ManualsContentsPreviousNextHelp

Connecting to the Gigabit Ethernet Interface

This section describes how to connect the Ethernet interface cable to the Gigabit Ethernet port.

Important

  1. Attach the ferrite core supplied with the machine to the machine end of the Ethernet interface cable. Make a loop about 10 cm (4 inch) (1) from the end and attach the ferrite core supplied with the optional Gigabit Ethernet board.

    Illustration of Gigabit Ethernet cable with ferrite core

  2. Make sure the main power switch of the machine is off.

  3. Connect the Ethernet interface cable to the Gigabit Ethernet port.

    Illustration of connecting Gigabit Ethernet cable

  4. Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

  5. Turn on the main power switch of the machine.

    Gigabit Ethernet port illustration (numbered callout illustration)

    1. Indicator (yellow)

      When 100BASE-TX is operating, the LED is lit yellow. When 10BASE-T is operating, it is turned off.

    2. Indicator (green)

      When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating it is turned off.

    3. Indicators (both yellow and green)

      When 1000BASE-T is operating, both LED are lit.

    Note

    • If the optional Gigabit Ethernet board is installed, only the Ethernet interface and USB interface on the Gigabit Ethernet board can be used.

    • For details about how to turn on the main power switch, see "Turning On the Power", About This Machine.

    • For details about installing the printer driver, see "Preparing the Machine", Printer Reference.