Skip headerimage
ManualsContentsPreviousNextHelp

Connecting to the Ethernet Interface

This section describes how to connect Ethernet interface cable to the Ethernet interface.

Important

  1. Attach the supplied ferrite core at the machine end of the Ethernet interface cable.

    Illustration of Ethernet cable with ferrite core

  2. Make sure the main power switch of the machine is off.

  3. Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.

    Illustration of connecting the Ethernet interface cable

  4. Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

  5. Turn on the main power switch of the machine.

    10BASE-T/100BASE-TX port illustration (numbered callout illustration)

    1. Indicator (yellow)

      When 100BASE-TX is operating, the LED is lit yellow. When 10BASE-T is operating, it is turned off.

    2. Indicator (green)

      When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating it is turned off.

    Note

    • For details about how to turn on the main power switch, see "Turning On the Power", About This Machine.

    • For details about installing the printer driver, see "Preparing the Machine", Printer Reference.