Skip headerGelSprinter GX7000
ContentsPreviousNextHelp

Top Page > Preparing for Printing > Connecting the Computer and Installing the Software (Network Connection) > Before Installing the Software (Network Interface Board) > Connecting the Printer via the Network

Connecting the Printer via the Network

Be sure to install all necessary network equipment, such as hubs, etc. before connecting the Ethernet cable to the printer.

You can connect a 10BASE-T or 100BASE-TX cable to the printer.

Important

  1. Plug the Ethernet cable into the Ethernet port on the rear of the printer.

    image

  2. Connect the other end of the cable to the printer's network, such as to a hub.

Check the LEDs on the Ethernet port

image

  1. Indicator (green)

    Remains green as long as the machine is properly connected to the network via 100 BASE-TX cable. Unlit if 10 BASE-T cable is connected.

  2. Indicator (orange)

    Lights whenever the printer is sending or receiving data via the network.

  3. [Reset] key

    Press this to initialize and reboot the network interface board.

TopPreviousNext
Copyright (C) 2007