Skip header
Screen reader supported pageStandard
 

Top Page > Preparing for Printing > Connecting the Computer and Installing the Software (Network Connection) > Before Installing the Software (Network Interface Board) > Specifying Settings on the Control Panel

Specifying Settings on the Control Panel

Make the following network settings according to the network interface you are using.

If you have connected the printer to a network, make the required network environment settings.

The following table shows the control panel settings and their default values. These items appear in the [Network Setup] menu.

Setting Name

Value

1.DHCP

On

2.IP Address

0.0.0.0

3.Subnet Mask

0.0.0.0

4.Gateway Address

0.0.0.0

5.Active Protocol

TCP/IP: Active

6.Ethernet Speed

Auto Select

The following example explains making settings for TCP/IP.

1Press the [Power] key.

image

2Press the [Menu] key.

image

The Menu screen appears on the display.

3Press the [Up arrow key] or [Down arrow key] key to display the [Host Interface] menu, and then press the [#Enter] key.

Menu:           
 Host Interface 

4Press the [Up arrow key] or [Down arrow key] key to display [Network Setup], and then press the [#Enter] key.

Host Interface: 
 Network Setup  

5Press the [Up arrow key] or [Down arrow key] key to select [IP Address], and then press [#Enter] key.

Network Setup   
 IP Address     

The current IP address appears on the display.

6Press the [Up arrow key] or [Down arrow key] key to enter the left most entry field of the IP address, and then press the [#Enter] key.

IP Address:     
  .  0.  0.  0 

To get an IP address for the printer, contact your network administrator.

The value moves by 10 if the [Up arrow key] or [Down arrow key] key is kept pressed.

When the [#Enter] key is pressed, the cursor moves to the next field.

7Press the [#Enter] key.

As the specified value is entered in each field, the cursor moves to the next field.

IP Address:     
 192.  .  0.  0

8Repeating the steps, specify values in all fields, and then press the [#Enter] key.

To return to the previous field, press the [Escape] key.

9Specify “Subnet Mask” and “Gateway Address” in the same way as when specifying the IP address.

10After you have made all the settings, press the [Online] key.

The specified settings are set and the initial printer screen reappears.

You can print the configuration page to confirm the specified settings.

Reference