BackForward
Search

User GuidePro C7500/C7500H

Waiting Time Prior to Printing is Too Long (Other than Envelope)

After receiving a print job, the machine usually stops to let the fusing temperature reach an appropriate level for printing.

Solution:

By decreasing the fusing temperature during standby, you can reduce the waiting time.

By changing the fusing temperature to feed paper after warm-up, you can also reduce the waiting time.

1If the paper is not registered as custom paper, register the brand of the paper.

2In [Detailed settings] for custom paper, check the fusing temperature at [Heat Roller Temp] in 1232: [Fusing Temperature].

  • 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp

  • 1232-06: Fusing Temperature: FCS: Heat Roller Temp: Clear/Special

  • 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White

  • 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic

  • 1232-26: Fusing Temperature: S: Heat Roller Temp: Clear/Special

  • 1232-27: Fusing Temperature: S: Heat Roller Temp: White

  • 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic

  • 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp

  • 1232-51: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Clear/Special

  • 1232-52: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: White

  • 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic

  • 1232-71: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Clear/Special

  • 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White

  • 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic

3Check if the fusing temperature is 140°C or lower.

Yes

Go to the next step.

No

Proceed to Step 5.

4In 0403: [Fusing Temperature on Standby] in [Operator Adjust.], decrease the values of the following items by 10°C.

01: Heat Roller: On Standby

02: Heat Roller: On Panel Off

07: Pressure Roller: Before Process

5In [Detailed settings] for custom paper, increase the value for 1235: [Fusing Temperature Range] by +3.

You can increase the value up to +9. Be sure not to exceed this value.

Note

  • Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic" when using Gold or Silver.

  • If the fusing temperature at which paper feeding is allowed is changed, there may be some differences in image gloss and fusibility between the print results at the initial paper feeding and subsequent printouts.

  • After performing the solution, it is recommended to perform the color calibration of the external printer controller.