09: Finishing: Stacker

Adjust the alignment width in Main Jogger at the Stacker to reduce dispersion of sheets at right angles due to paper size, thickness, curl, etc.

Adjust the alignment width in Sub Jogger at the Stacker to reduce dispersion of sheets at right angles due to paper size, thickness, curl, etc.

Adjust the alignment position of the Tip Stopper at the Stacker to reduce variations of paper orientation in the feeding direction due to paper size, thickness, curl, etc.

Adjust the alignment width of the Main Jogger of the Second Stacker. It reduces variations in paper orientation at right angle due to paper size, thickness, curl, etc.

Adjust the alignment width of the Sub Jogger of the Second Stacker. It reduces variations in paper orientation at right angle due to paper size, thickness, curl, etc.

Adjust the alignment position of the Tip Stopper of the Second Stacker. It reduces variations in paper alignment in the feeding direction due to paper size, thickness, curl, etc.

Specify the maximum number of sheets that can be stacked on the stacker tray. If the unit detects that the number of sheets reaches the set upper limit, a warning message will appear.

The maximum number of sheets you can set differs depending on the size, thickness, and paper curl. Set the maximum number by specifying a ratio based on the number of sheets. Select [Large Size] when using paper whose vertical and horizontal lengths are 210 mm or longer whose area is 8¹/₂ × 11 or wider. Select [Small Size] when using other size paper.

Major paper sizes that apply to each item are as follows: