1303: 2-Tray LCIT: Other Settings
Adjust feed timing by setting wait time of blowing to float paper in Wide Large Capacity Tray.
* If double feed occurs at the start of the job, set a longer time for waiting.
Setting Item | Max. Value | Min. Value | Step | Unit |
|---|---|---|---|---|
01: Paper Floating Wait Time | 5 | 3 | 0.1 | second |
Extend Fan Operating Time
Set to [On (Improve Separation)] for paper that is likely to double feed or not feed. Setting a longer fan operating time improves separation. However, the paper feed interval is longer, which may lower productivity.
Setting Item | Values |
|---|---|
02: Setting | Off On (Improve Separation) |
Prevent Initial Nonfeed
Set to [On] for paper that is likely to not feed immediately after printing starts, but which is not improved by setting [Prevent Non Feed] in [Paper Feed Mode: Fan Level]. Elevating the bottom plate of the tray immediately after printing starts helps to prevent non-feeding.
Setting Item | Values |
|---|---|
03: Setting | Off On |
Tray Elevation Assist
Set the timing at which tray elevation assist starts.
Setting Item | Values |
|---|---|
04: Assist Mode | Off Assist On When Remaining Paper Low Always Assist On |
Specify the thickness of paper (measured value) when you specify [Always Assist On] or [Assist On When Remaining Paper Low] in [Assist Mode].
An initial value is specified by default when you are not entering the value that you measured on paper in [Paper Thickness]. Do not change the default value in the case.
Setting Item | Max. Value | Min. Value | Step | Unit |
|---|---|---|---|---|
05: Paper Thickness | 2,000 | 20 | 10 |
|
mSpecify the ascending speed of the tray when you specify [Always Assist On] or [Assist On When Remaining Paper Low] in [Assist Mode].
Setting Item | Values |
|---|---|
06: Speed | Slowest Slower Standard Faster Fastest |