User GuideIM 550/600 series

When an Error Is Reported in a Report or E-mail

The machine notifies the user when a malfunction or error occurs via a report or e-mail as described below.

Type

Cause

Error report

Communication could not be established normally because of noise on the telephone line or a malfunction occurring on the machine or the fax device at the destination.

Power off report

Documents stored in the memory were deleted because the power distribution to the machine was interrupted for more than one hour as a result of a power outage or a bad electrical contact in the power plug.

Error mail sent from the server

A transmission could not be performed normally in the Internet Fax function.

Error notification e-mail (Error Report)

An e-mail could not be received without using the SMTP server in the Internet Fax function.

Error report (e-mail)

The machine could not send an error notification e-mail (Error Report) when an e-mail could not be received without using the SMTP server in the Internet Fax function.

Error Report

  • "User Name" shows the sender name.

  • Check "Destination" and send the fax again.

  • "Mode" shows "Receive" if an error occurred during reception. Request the sender to send the document again.

Power Off Report

  • "Time" shows the time when the document was stored in the memory.

  • If "Transmission Condition" shows Memory Transmission and "Result" shows an error or stand-by, check the description in "Destination" and send the document again.

  • If "Transmission condition" shows Memory Reception or Substitute Reception, and "Result" shows an error, ask the sender to send the document again.

Note

  • The report may not show the line type of the destination and the expanded destination data (SEC code/sub address/UUI) depending on various conditions, such as the duration of the power outage.

  • If another power outage occurs within 24 hours after the first power outage occurred, documents in the memory may be deleted and the Power Off Report is generated even if the duration of the second power outage is less than one hour.

Error Mail Sent from the Server

The first page of the sent document is also printed.

  • The description may vary per destination. See "reason" or another field for the cause, and remedy the send conditions such as the destination setting or file size, and then send the document again. If the error was caused by something at the destination, such as insufficient memory, contact a person at the destination.

Note

  • If an e-mail could not be sent in "Fax (Classic)", a send-error notification e-mail is sent to the e-mail address of the user who attempted to send the fax, and a carbon copy (CC) of the e-mail is also sent to [Administrator's Email Address] in [System Settings]. The e-mail transmission error report is printed when the machine cannot send the send-error notification e-mail.

Error Notification E-mail (Error Report)

The machine sends an error notification e-mail (Error Report) to the sender, and a carbon copy (CC) of the e-mail is also sent to [Administrator's Email Address] in [System Settings].

  • If "Error Type" shows Invalid File (Code Error), change the transmission method, character code, or format of the attached file, and send the e-mail again.

  • If "Error Type" shows Memory Over Error, check the remaining amount of memory on the machine.

    Checking the Remaining Amount of Memory

  • If "Error Type" shows Memory Access Error, check that no malfunction is occurring on the machine.

Error Report (Email)

  • If "Error Type" shows a file, ask the sender to change the e-mail transmission method, character code, or format of the attached file, and to send the e-mail again.

  • If "Error Type" shows a reason other than a file, check that the machine is functioning normally and there is a sufficient amount of free space in the memory, and then have the sender resend the e-mail.

    Checking the Remaining Amount of Memory