Skip header
 

Solution:

The solution depends on the type of unevenness.

Carry out the appropriate procedure from those in the following table:

(A) The density is uneven across the entire image.

Affected area

Solution

The density from top to bottom is uneven.

Illustration of density problems

  1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu, select 0202: [Adjust Image Density] and execute [Adjust Image Density].

  2. If the problem persists, see Uneven Density from Top to Bottom.

The sides are fainter or denser.

Illustration of density problems

  1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu, select 0202: [Adjust Image Density] and execute [Adjust Image Density].

  2. If the problem persists, contact your service representative.

The top and bottom are fainter or denser.

Illustration of density problems

  1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu, select 0202: [Adjust Image Density] and execute [Adjust Image Density].

  2. If the problem persists, contact your service representative.
(B) The density is uneven in a part of the image.

Affected area

Solution

The leading edge is fainter.

Illustration of density problems

  1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu, select 0202: [Adjust Image Density] and execute [Adjust Image Density].

  2. If the problem persists, see Fainter Leading Edge.

The trailing edge is fainter.

Illustration of density problems

  1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu, select 0202: [Adjust Image Density] and execute [Adjust Image Density].

  2. If the problem persists, see Fainter Trailing Edge.

The center is fainter or denser

Illustration of density problems

  1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu, select 0202: [Adjust Image Density] and execute [Adjust Image Density].

  2. If the problem persists, contact your service representative.

Wavy unevenness

Illustration of density problems

  1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu, select 0202: [Adjust Image Density] and execute [Adjust Image Density].

  2. If the problem persists, contact your service representative.
(C) The density is uneven in the direction perpendicular to the paper feed direction at regular intervals.

Affected area

Solution

Periodic vertical density fluctuation

Illustration of density problems

  1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu, select 0202: [Adjust Image Density] and execute [Adjust Image Density].

  2. If the problem persists, see Periodic Density Fluctuation.
PreviousNext