Previous
Select [Machine: Image Quality] in [Advanced Settings] for the custom paper in use, select 1202: [Image Transfer Output].
Check the present value. Is it lower than 100 
A?
Yes |
Carry out all of the following: (1) Increase the value by 5 (2) Set [Trailing Edge] of 1204: [Paper Transfer Output Correction: Paper Edge] to "200%". (3) Set [Trailing Edge Length] of 1204: [Paper Transfer Output Correction: Paper Edge] to "30 mm". |
No |
No further improvement is likely. Contact your service representative. |
Print the image. Is the problem resolved?
Yes |
Finished! |
No |
Repeat Steps 1 to 3. If the problem persists even though you have increased the value to 100 |
