Top Page > Replacement Guide: TCRU/ORU > Read This First > Safety Precautions to Be Followed > Handling the machine’s supplies
|
Do not use a vacuum cleaner to remove spilled toner (including used toner). Absorbed toner may cause a fire or explosion due to electrical contact flickering inside the vacuum cleaner. However, it is possible to use a vacuum cleaner that is explosion-proof and dust ignition-proof. If toner is spilled on the floor, remove the spilled toner slowly using a wet cloth, so that the toner is not scattered.
|
|
The fusing unit becomes hot. When removing the fusing unit, wait for 20 minutes or more after opening the cover and confirm that the fusing unit is not hotter than the room temperature. Otherwise, you will be burned.
|
|
The fusing unit weighs approximately around 17.0 kg (37.5 lb).
When moving the fusing unit, lift it slowly and be careful not to strain yourself. Careless handling or over-exertion when lifting can result in breakage of the unit or injury to yourself.
|
|
Do not crush or squeeze toner containers. Doing so can cause toner spillage, possibly resulting in dirtying of skin, clothing, and floor, and accidental ingestion.
|
|
When removing jammed paper or replacing toner, avoid getting toner (new or used) on your clothing. If toner comes into contact with your clothing, wash the stained area with cold water. Hot water will set the toner into the fabric and make removing the stain impossible.
|
|
Avoid getting toner on your clothes or skin when replacing toner filter. If your skin comes into contact with toner, wash the affected area thoroughly with soap and water.
If toner gets on your clothing, wash with cold water. Hot water will set the toner into the fabric and may make removing the stain impossible.
|
|
When removing jammed paper or replacing toner, avoid getting toner (new or used) on your clothing. If toner comes into contact with your clothing, wash the stained area with cold water. Hot water will set the toner into the fabric and make removing the stain impossible.
|
|
When replacing a toner or waste toner container or consumables with toner, make sure that the toner does not splatter. Put the waste consumables in a bag after they are removed. For consumables with a lid, make sure that the lid is shut.
|
|
Do not attempt to print on stapled sheets, aluminum foil, carbon paper, or any kind of conductive paper. Doing so risks fire.
|