Host Interface
Network Config. Wizard | LAN Settings | Wired LAN |
Wireless LAN | ||
USB Port |  Active,Inactive (default)  Active (default), Inactive | |
Direct Connection Setting | Active, Inactive (default) | |
SSID | Device Name | |
Fix SSID (On, Off (default)) | ||
Connection Password | ||
IPv4 Address | ||
Connection Status | ||
Smart Device Connector | Guest Use | Allow, Prohibit (default) |
HTTPS Connection | Use, Do not Use (default) | |
QR Code Print | ||
I/O Buffer | 128 KB (default), 256 KB | |
I/O Timeout | 10 seconds, 15 seconds (default), 20 seconds, 25 seconds, 60 seconds | |
DIPRINT Timeout Period | 5 to 65535 seconds Default: 15 | |
Network
Machine IPv4 Address | Auto-Obtain (DHCP) (default) | |
Specify | ||
IPv6 Stateless Setting | Active(default), Inactive | |
DHCPv6 Configuration | DHCPv6 Setting | Active, Inactive (default) |
Operation Mode | Router Request(default), Obtain IP Address, Do not obtain IP Address | |
DNS Server Address | Auto-Obtain (DHCPv6)(default), Specify | |
IPsec | Active, Inactive (default) | |
Effective Protocol | IPv4 | Active(default), Inactive |
IPv6 | Active, Inactive (default) | |
SMB | Active(default), Inactive | |
@Remote Service | Active(default), Inactive | |
Firmware Update (IPv4) | Active(default), Inactive | |
Firmware Update (IPv6) | Active(default), Inactive | |
Ethernet Speed | Auto Select: Enable 1Gbps, Auto Select: Disable 1Gbps(default), 10Mbps Half Duplex, 10Mbps Full Duplex, 100Mbps Half Duplex, 100Mbps Full Duplex | |
IEEE802.1X Auth.(Ethernet) | Active, Inactive (default) | |
Restr.IEEE802.1X Auth.Def. | ||
LAN Type | Ethernet(default), Wireless LAN | |
Permit SSL/TLS Comm. | Ciphertext Only, Ciphertext Priority, Ciphertext/Cleartext (default) | |
Parallel Interface
Parallel Timing | ACK inside, ACK outside (default), STB down |
Parallel Comm. Speed | High Speed (default), Standard |
Selection Signal Status | High(default), Low |
Input Prime | Active, Inactive (default) |
Bidirectional Comm. | On(default), Off |
Wireless LAN
WLAN: EasySetup/Direct Con | Push Button Method (default), PIN Code Method | |
Communication Mode | 802.11 Ad-hoc Mode, Infrastructure Mode(default), Dir Con: Group Owner Mode, Direct Connection Mode | |
SSID Setting | ||
Ad-hoc Channel | 1–11, 36, 40, 44, 48 Default: 11 | |
Security Method | Off (default) | |
Security Method | WEP | |
Security Method | WPA2 | Authentication Method
|
Direct Connection Settings | Device Name | |
Connection Password | ||
Display IPv4 Address | ||
Connection Status | ||
Wireless LAN Signal | ||
Restore Defaults | ||
USB Port
USB Port | Active, Inactive (default) Active (default), Inactive |
USB Settings
USB Speed | Auto Select(default), Full Speed |
Fixed USB Port | Level 1, Level 2, Off(default) |
Restore Interface Settings
Restore Interface Settings |