Cleaning the Machine
Smears or dust may appear on copied documents or scanned images when the exposure glass, scan glass, ADF, or dustproof glass becomes dirty. Clean those parts.
- Contact your sales or service representative for cleaning the machine's interior. If the machine's interior is not regularly cleaned while dust accumulates, fire and malfunction can result.
Do not use chemicals such as cleaning liquid and organic solvents such as paint thinner and benzene for cleaning. It may seep inside the machine through the gaps or melt the plastic material composing the exterior cover, causing malfunctions to occur.
Your service representative will replace the ozone and dust filters as needed.
Cleaning the Exposure Glass and Scan Glass
Use the cleaning cloth provided with the machine to wipe the parts.
Wipe the exposure glass and scan glass.
![Exposure glass illustration numbered callout illustration](../../maintain/image/ebw110.gif)
Cleaning the Auto Document Feeder (ADF)
Use a dry soft cloth to wipe the part.
Wipe the seat and guide plate in the ADF.
![Auto document feeder illustration](../../maintain/image/ebw107.gif)
If dirt does not come off when wiped with a dry cloth, use a cloth that has been soaked in water and thoroughly wrung out.
If dirt does not come off even when wiped with a wet cloth, use neutral detergent and use a dry cloth to wipe off any moisture.
Cleaning the Dustproof Glass
Use the cleaning rod provided with the machine for cleaning.
- When performing maintenance on the machine, disconnect the power cord from the wall outlet for safety.
Do not insert the cleaning rod forcefully. Doing so may damage the interior of the machine.
Turn off the power of the machine and remove the power plug from the wall outlet.
Open the front cover of the machine.
Take out the cleaning rod from the front cover.
While unhooking the claws, pull the handle of the cleaning rod upward.
![Operation procedure illustration](../../maintain/image/ebw002.gif)
While keeping the surface with the arrow facing up, insert and then pull out the rod in the slot two or three times.
Insert the rod carefully until it stops, and then pull it out.
![Operation procedure illustration](../../maintain/image/ebw004.gif)
Set the cleaning rod back on the front cover, and then close the cover.
![Operation procedure illustration](../../maintain/image/ebw005.gif)
Plug the power cable into the wall outlet, and then turn on the power of the machine.