User GuideIM 350/430 series

Attaching the Paper Feed Unit

WARNING

  • It is dangerous to handle the power cord plug with wet hands. Doing so could result in electric shock.

CAUTION

  • The machine weighs approximately 30.5 kg (67.3 lb.) (Main unit only, including consumables.).
  • When moving the machine, use the inset grips on both sides, and lift slowly in pairs. The machine will break or cause injury if dropped.
  • Lifting the paper feed unit carelessly or dropping may cause injury.
  • CAUTION

    • Unplug the power cord from the wall outlet before you move the machine. While moving the machine, take care that the power cord is not damaged under the machine. Failing to take these precautions could result in fire or electric shock.

    Important

    • Do not place the machine directly on the floor.

    • When attaching multiple options, attach the paper feed unit first.

    • To attach two paper feed units at the same time, first stack them one upon the other, and then attach them as a single unit.

    • Before turning on the power, remove the packaging material from the paper feed unit.

    1Check the contents of the package.

    2Turn the machine off and unplug the power cord.

    3Remove the packaging from the paper feed unit.

    4Lift the machine using the inset grips on both sides of the machine.

    Illustration of the main unit.

    When moving the machine, do not hold on the following parts as doing so could cause a malfunction:

    • The handle onto the standard paper feed tray

    • The underside of the bypass tray

    5There are three upright pins on the optional paper feed unit. Align them with the holes on the underside of the machine, and then carefully lower the machine.

    Illustration of the main unit and paper feed unit.

    6Plug in the power cord, and then turn on the machine.

    7Print the configuration page to confirm that the unit was attached correctly.

    Note

    • To confirm whether the optional paper feed unit was correctly attached, print the configuration page, and check "Attached Equipment" on the configuration page. If the unit was attached correctly, "Tray 2" - "Tray 4" will appear.

    • If the optional paper feed unit was not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after reattempting installation, contact your sales or service representative.

    • To use the paper feed unit, configure the machine options in "Accessories" in the printer driver. For details about opening "Accessories", see "Configuring Option Settings for the Printer", Driver Installation Guide.