User GuideIM 350/430 series

Scanning part of a custom size original

If you want to scan only a part of a custom size original, select [Partial Scan] as the scan size.

To display the custom size setting screen, on the initial scanner screen, press [Scan Settings] > [Scan Size] > [Partial Scan].

To scan part of an original, measure Original Size (X1 and Y1), Start Position (X2 and Y2), and Scan Area (X3 and Y3) on the surface of the original, and then enter those values in the same order on the custom size setting screen.

Measuring methods differ depending on where the original is placed and the orientation it is placed in. For details about how to measure Original Size (X1 and Y1), Start Position (X2 and Y2), and Scan Area (X3 and Y3) correctly, see "How to measure sizes".

How to measure sizes

Orientation and placement of original

Measuring method for scanning the "R" section

In the Operation panel screen illustration orientation on the exposure glass or in the ADF.

Illustration of original size

In the Operation panel screen illustration orientation in the ADF.

Illustration of original size

In the Operation panel screen illustration orientation on the exposure glass.

Illustration of original size

Scan settings on the partial scan setting screen

Operation panel screen illustration numbered callout illustration
  1. Original Size (X1 and Y1)

    Specify the original's entire size.

    Enter the actual values in [X1] and [Y1] while referring to "How to measure sizes", and then press [Sharp].

  2. Start Position (X2 and Y2)

    Specify the scanning start position.

    Enter the actual values in [X2] and [Y2] while referring to "How to measure sizes", and then press [Sharp].

  3. Scan Area (X3 and Y3)

    Specify sizes of the area you want to scan.

    Enter the actual values in [X3] and [Y3] while referring to "How to measure sizes", and then press [Sharp].

Note