User GuideIM 350/430 series

Enabling WSD (Pull Type) Using a Web Browser

To use this machine as a WSD scanner, you must first configure the following settings using a web browser on a client computer: (We use Web Image Monitor installed on this machine.)

  • Settings to enable WSD (Pull Type)

    • WSD protocol (default setting: [Active])

      To use IPv4, Click [Device Management], click [Configuration], click [IPv4] under [Network], and then enable [WSD (Device)] and [WSD (Scanner)].

      To use IPv6, set [WSD (Device)] or [WSD (Scanner)] for IPv4 to inactive (disabled).

      • In an IPv6 environment, only link local addresses can be used for WSD communication.

    • [Prohibit WSD Scan Command] (default setting: [Prohibit])

      Click [Device Management], click [Configuration], click [Initial Settings] under [Scanner], and then set [Prohibit WSD Scan Command] to [Do not Prohibit].

Use the following procedure to enable both WSD (Pull Type).

1Enter "http:// (machine IP address, or host name)/" in the address bar of the client computer's web browser, and then press the [Enter] key.

2Click [Login].

3Enter login user name and password in the [Login User Name] and [Login Password] boxes respectively, and then click [Login].

Consult your administrator if you require a login user name and password.

4On the menu in the left frame, select [Device Management], and then click [Configuration].

5Under [Scanner], click [Initial Settings].

6Select [WSD] in [Use WSD or DSM].

7Set [Prohibit WSD Scan Command] to [Do not Prohibit].

8Click [OK].

Note

  • For details about displaying Web Image Monitor, see "Using a Web Browser", Settings. For details about using Web Image Monitor, see Web Image Monitor Help.