Cleaning the Paper Feed Roller or Friction Pad of the ADF
If the paper feed roller or friction pad is dirty, a multi-feed or misfeed might occur.
Clean these parts by following the cleaning procedure below.
While holding down the ADF with one hand, slowly open the ADF cover
.
![Auto document feeder illustration numbered callout illustration](../../maintain/image/dvk034.gif)
While pushing the bar of the ADF paper feed roller toward the rear side of the main body, lift it up and remove it.
![Auto document feeder illustration](../../maintain/image/dvk035.gif)
Turn over the ADF paper feed roller.
![ADF paper feed roller illustration](../../maintain/image/dvk036.gif)
Remove any dirt from the ADF paper feed roller
.
Use a soft, damp cloth that has been tightly wrung out.
![ADF paper feed roller illustration numbered callout illustration](../../maintain/image/dvk037.gif)
Remove any dirt from the separation pad
.
Use a soft, damp cloth that has been tightly wrung out.
![Auto document feeder illustration numbered callout illustration](../../maintain/image/dvk038.gif)
While pushing the rod of the ADF paper feed roller toward the rear side of the main body, reinstall it in its original position.
![Auto document feeder illustration](../../maintain/image/dvl921.gif)
Close the ADF cover slowly.
Be careful not to pinch your fingers.
Close the ADF cover by pushing the center part.
![Auto document feeder illustration](../../maintain/image/dvk040.gif)