User GuideIM 350/430 series

How to Replace the Drum Unit

Important

  • Place the drum unit on a flat surface. Do not stand the drum unit on end or lean it against an object.

  • When carrying the combined unit, do not touch the lock lever. The lock may be released, causing the drum unit to fall off.

  • When you replace the drum unit, replace it immediately since the performance may be reduced if the drum unit is exposed by a light for a long period.

  • Close all paper trays and optional paper feed units before opening the front cover.

1Open the box and remove the cardboard.

Drum unit illustration

2Hold the packaging on the left and right to take out the new drum unit.

Drum unit illustration

3Remove the packaging.

Drum unit illustration

4Take the drum unit out from the bag.

Drum unit illustration

Do not touch the parts illustrated below.

Drum unit illustration

5Remove the desiccant from the drum unit and put the drum unit on a level surface.

Drum unit illustration

6Hold the both sides of the control panel and make it horizontal.

Control panel illustration

7Press the front cover open button on the right side of the machine to open the front cover.

Front cover illustration

8Hold the handle of the combined unit with both hands, and then pull it out.

Do not touch the lock lever when pulling out the combined unit.

Spread a piece of paper on a level surface and then place the combined unit on top of it.

Combined unit illustration

9Clean the registration roller and the parts around the transfer roller.

See Cleaning Around the Transfer Roller and Cleaning the Registration Roller for the procedure for cleaning.

10Pull the lock lever forward to release the lock in two steps.

Pull down the lock lever until it is level and align it with the triangle mark.

Combined unit illustration
Combined unit illustration

11Hold the drum unit by hand and hold the handle of the print cartridge to pull it forward to detach it from the drum unit.

Print cartridge illustration

Do not touch the part illustrated below.

Print cartridge illustration

12Put the used drum unit in the bag which the new drum unit was in.

Drum unit illustration

13Hold the handle of the print cartridge with both hands, and then use the arrow marks on the left and right sides as a guide to connect it to the new drum unit.

Drum unit illustration
Drum unit illustration
Drum unit illustration

14Push the lock lever to the back to lock it.

Combined unit illustration

15Hold the handle of the combined unit with both hands, and then insert it along the rails.

At first, lift the handle and place the combined unit slightly into the opening of the machine. When the combined unit fits in the rails, insert it into the machine.

Combined unit illustration

Insert the combined unit until it stops.

16Close the front cover.

Front cover illustration

17Hold the both sides of the control panel and tilt it at an appropriate angle.

18Attach the packaging to the used drum unit over the bag and put it in the box.

Drum unit illustration

When discarding used drum unit, see Disposing of Used Drum Unit.